Click this icon, the camera will rotate up and down, i.e., vertical tilt, click to stop it
Click this icon, the camera will rotate left and right, i.e., horizontal pan, click to stop it
Click this icon, IO output Switch ON. Click to set it OFF.
Multi-Camera Display
NOTE: If you want to view 4/9 channels, you should set the Multi-Device first
View a single camera
View 4 cameras
View 9 cameras
PTZ speed: set value from 1 to 100, click the icon, it will change back to the factory settings.
Brightness: set value from 0 to 255, click the icon, it will change back to the factory settings.
Contrast: set value from 0 to 255, click the icon, it will change back to the factory settings.
Hue: set value from -128 to 127, click the icon, it will change back to the factory settings.
Zoom-: Zoom in feature
Zoom+: feature Zoom out
To Next Page
Loading...
Need help?
General
