QNAP TS-410 User Manual

8. R
otate the memory module towards the motherboard until the securing clips clicks
into place.
9. Close the case cover and fasten the screws. Connect the power adaptor and cables
back to the NAS.
10. To check that the memory module is recognized by the NAS, power up the NAS and
login the web interface as an administrator. Go to "System Status" > "System
Information" and check the total memory in "Hardware Information".
26

QNAP TS-410 Specifications

General

CPU	Marvell 6281
CPU Frequency	800 MHz
Flash Memory	16 MB
Drive Bays	4
LAN Ports	1 x Gigabit RJ-45 Ethernet port
Dimensions	177 x 180 x 235 mm
Weight	3.6 kg
Hot Swappable	Yes
RAID Support	RAID 0, 1, 5, 6, JBOD
USB Ports	3 x USB 2.0
eSATA Ports	2
Maximum Internal Raw Capacity	16 TB (4 x 4 TB hard drives)