QNAP TVS-672XT - 4. Basic Operations; Power Button; Reset Button

4. Basic Operations
This chapter describes basic NAS operations.
Power Button
Operation User Action Result
Power on Press the button once. The NAS powers on.
Power o Press and hold the button for
1.5 seconds.
The NAS powers o.
Force power o Press and hold the button for 5
seconds.
The NAS shuts down.
Important
Use this method only when the NAS
is unresponsive.
Reset Button
Operation User Action Result
Basic
system
reset
Press and hold
the button for 3
seconds.
The following settings are reset to default:
• The admin account is automatically enabled.
• System administrator password: For details on the default
password, see this FAQ.
• TCP/IP conguration:
• Obtain IP address settings automatically via DHCP
• Disable jumbo frames
• If port trunking is enabled (multi-LAN models only),
the port trunking mode is reset to “Active Backup
(Failover)”.
• System port: 8080 (system service port)
• Security level: Low (Allow all connections)
• LCD panel password: (blank)
• VLAN: Disabled
TVS-x72XT User Guide
Basic Operations 52