QNAP TVS-672XT - Installing QTS Using an HDMI Connection

14. Congure the network settings using any of the following methods.
Methods User Actions
Obtain an IP
address automat‐
ically (DHCP)
Select Obtain an IP address automatically (DHCP)
The system automatically detects and congures the IP address
settings.
Use static IP
address
a. Select Use static IP address.
The IP address conguration page appears.
b. Specify the following IP address congurations:
• Interface
• IP Address
• Subnet Mask
• Default Gateway
• Primary DNS server
• Secondary DNS server
15. Click Next.
The Thunderbolt Connection page appears.
Note
This page only appears if your device supports Thunderbolt. You will need to connect your
device to a computer using a Thunderbolt cable.
16. Click Next.
The Summary screen appears.
17. Review the settings.
18. Click Apply.
A conrmation message appears.
Warning
Clicking Conrm deletes all data on the drive before installing QTS.
19. Click Conrm.
QTS is installed.
Installing QTS Using an HDMI Connection
Warning
Installing QTS deletes all data on the drives. Back up your data before proceeding.
TVS-x72XT User Guide
Installation and Conguration 49