NETWORK STATUS:
Not in network: When a device has been paired but has
not yet been plugged in it will show Not in Network.
These devices can also be deleted using the trash can.
Started: Once the device has been paired and then
plugged in, it will start the inclusion process with the
panel and run in the back ground.
Included: When a device has completed the inclusion
process it will then show as “included” in the
provisioning list and at that point the panel’s UI will
reflect the included devices.
Provisioning List
Devices added via SmartStart will show up in the provision list. This list will show the network status of those
devices. Once a devices reaches the “Included” state on the panel, it can no longer be deleted using the trash
can method and must follow standard clearing process.
To Next Page
Loading...
Need help?
General
