3. Tap the [on/off] button to set the Stop counter to ‘on’ or ‘off’.
If you set the Stop counter to ‘on’ you can enter the ‘Stop at value’. Enter a value from
5 through 9999.
Be aware that when the system stops based on the stop counter,
there can still be documents in the system. To clear the system
from documents, remove the documents from the feeder trays and
tap [Start] from the warning message; the remaining documents
will be processed to clear the system.
4.
Tap the
[ ]
button for the Job total counter to set it to zero.
If you set the Job total counter to zero the number history of this
job will be lost.
5. Tap [√] to go back to the job overview screen and tap [Start].
Finish the Job Definition and Start the Job
When you have finished the exit settings, the touch screen shows an overview of the job
settings.
In this screen you can change the following settings:
• Move documents between feeders (see Change to an other feeder tray on page 53)
• Link feeders (see Link feeder trays on page 54)
• Change the counter settings (see Change the counter settings on page 38)
When you are ready with these settings, proceed as follows:
Load the documents as indicated on the Job info screen (refer also to Load the
documents on page 64).
1.
40
| Page 40 | Jul-11-2022 07:45 | Working with Jobs
4
English
To Next Page
Loading...
