• BRE offset: in the case of offset is “yes”, the last document that was added to the
set is shifted from the rest of the set (offsetting, see below).
• Collator stop optimisation: if set to "off", the system does not show a message,
when a collator stop change can improve the system output.
Explanation of BRE offset: if a BRE is longer than the set fold but shorter than the envelope
height, this BRE can get folded (A in the figure). Under certain conditions (see below) you
can prevent the BRE from being folded. In the case of offset “yes”, the BRE is held back
during a certain distance (B in the figure). This means that the trailing edge of the BRE
leaves the collator last. The document is not folded. During the insertion into the envelope
the documents of the set are aligned.
6
English
91
| Page 91 | Jul-11-2022 07:45 | Settings menu
To Next Page
Loading...
