Quadra-Fire EXCURSION-I - Appliance Break-In; Heat Management

50
Quadra-Fire • EXCURSION-I, EXCURSION-II, EXCURSION-III Installation Manual • 2538-980 Rev. E • 5/19
K. Appliance Break-In
Follow the initial break-in procedure below to cure the
materials used to manufacture the replace and the
nishing materials around it.
• The fireplace should be run three to four hours
continuously on high ame and high fan.
• Turn the replace off and allow it to cool completely.
• Remove xed glass assembly. See Section 9.A.
• Clean xed glass assembly.
• Replace the xed glass assembly and run continuously
on high an additional 12 hours.
NOTICE! This product comes equipped with a fan that
provides remote control of heat output. See Section L.
Set the fan speed to high on the RC400 remote control
during the rst three to four hours of break-in operation.
This break-in will ensure optimum speed control of the fan
during subsequent use.
Note: The IntelliFire™ Touch system has a safety feature
that automatically shuts down the replace after 9 hours of
continuous operation without receiving a command from
the remote control. If this occurs, restart the appliance.
NOTICE! Open windows for air circulation during re-
place break-in.
• Some people may be sensitive to smoke and odors.
• Smoke detectors may activate.
L. Heat Management
Heat Output
Heat Output is managed through the RC400 remote con-
trol that comes standard with the replace.
• Turn the appliance on and off.
• Adjust the height of the ame by varying the input using
the remote control.
• Adjust the fan speed.
For more information, see the instructions that accompany
the remote control.
NOTICE! Set the fan speed to high on the RC400 remote
control during the rst three to four hours of break-in
operation. This break-in will ensure optimum speed control
of the fans during subsequent use.