Quantum DXi6900

Chapter 9: Configuration
OST Configuration
Quantum DXi6900 User’s Guide 265
AdditionalInformation
l You must add target IP mapping information if you are performing optimized duplication on a
segmented network and replication is not configured between the source DXi and target DXi.
l Quantum does not recommend mapping multiple data IP addresses to a single replication IP address.
If you have mapped multiple data IP addresses and the routing is not working, try removing the
additional data IP addresses, and map only a single data IP address.
l To switch from using the replication channel to the OST channel for optimized duplication, replication
must be unconfigured.
To access the TargetIPMapping page, on the OST page, click the TargetIPMapping tab (see Figure
163 below).
Figure163:Target IP Mapping Page
Tasks
Use the TargetIPMapping page to perform the following tasks:
l View information about mapped data and replication IP addresses (see Target IP Mapping List on the
next page).
l Map a target data IP address to a replication IP address (see Mapping a Target IP Address on the
next page).
l Edit the mapping for a target data IP address (see Editing a Mapped IP Address on the next page).
l Delete the mapping for a target data IP address (see Editing a Mapped IP Address on the next page).