Quantum DXi6900

Chapter 9: Configuration
Notifications
Quantum DXi6900 User’s Guide 292
Figure179:Server Page
To specify the outgoing e-mail server:
1. In the HostnameorIPAddress box, enter the hostname or IP address of the outgoing e-mail server.
AdditionalInformation
l When entering IP addresses, never use an address that is in a reserved IP address range. To
see a list of reserved IP address ranges, click the quick tip icon [?] located near the IP address
field.
l To use hostname format, you must specify at least one DNS IP address on the Network page
(see Network on page 305).
2. In the FromEmailAddress box, enter the return e-mail address displayed in e-mails sent by the
DXi6900.
Specify a return address that lets you easily identify the system that generated the e-mail (for example,
systemname@any-domain.com). The return address must contain an @ symbol and a valid domain
name, including a period.
3. (Optional) Select the EnableAdminAlertsaboutEmailServernotconfigured check box to have
system generate administration alerts to notify you if an e-mail server is not configured.
4. (Recommended) Select the EnableautomaticemailstoQuantumcheck box to periodically send
system configuration and status information to Quantum, including any software upgrades you have
installed using the SoftwareUpgradeUtility. Quantum Support can use this information to provide a
better support experience in the future.
Note:Automatic e-mails contain configuration and status information only, and do not contain any
customer data stored on the system.
5. Click Apply.