Quantum DXi6900

Chapter 9: Configuration
Notifications
Quantum DXi6900 User’s Guide 300
Use the Community page to perform the following tasks:
l View information about SNMP communities (see SNMP Community List below).
l Add an SNMP community (see Adding a Community below).
l Edit an SNMP community (see Editing a Community on page 302).
l Delete an SNMP community (see Deleting a Community on page 303).
SNMPCommunityList
The SNMPCommunityList displays the following information about SNMP communities:
Name The name of the community.
IPAddress The IP address of the community.
NetworkMask The network mask of the community.
AccessType The access type of the community (Get or Get/Set).
CommunityStatus The status of the community (Enabled or Disabled).
AddingaCommunity
Add an SNMP community to include the DXi6900 in a group of devices that are monitored by a common
management station.
Note:If no communities are defined, the SNMP agent is not accessible.
To add a community:
1. Click Add.
The AddSNMPCommunity page displays (see Figure 187 on the next page).