Quantum DXi6900 - Page 307

Chapter 9: Configuration
System
Quantum DXi6900 User’s Guide 307
DNSSuffixSearchList (Optional) The domain list to search when resolving domain names.
The list may be either a single domain name or a comma-separated list of up
to 6 domain names. The first domain name listed is used as the local
domain. Domain names must contain only letters [ A–Z, a–z ], numbers [ 0–
9 ], dots [ . ], and hyphens [ - ].
Primary,Secondary,and
TertiaryDNSIPAddress
(Optional) The IP addresses of up to three DNS servers used to resolve
domain names and translate them into IP addresses.
Note:You must specify a DNS IP address if you plan to use hostname
format when configuring an NTP time server, outgoing e-mail server,
replication sources and targets, and other information.
ConfiguringBondingDetails
Under IPAddressConfiguration>BondingDetails, configure bonded devices (see Figure 191 below):
Figure191:Network Page: Bonding Details
1. If necessary, click the Show link to show the bonding details table.
2. For each available bonded device (bond0, bond1, and so on), select two or more Ethernet ports with
the same link speed to assign to the bond. Or select NotBonded to leave a port unassigned to any
bond.
If no ports are assigned to a bond, the bond cannot be configured. That is, settings cannot be entered
for the bond in the InterfaceDetails or IPAddress tables because no Ethernet ports are assigned to
the device.
All ports assigned to the same device are bonded together into a single logical port. For example, if you
select bond0 for port eth0 and port eth1, both ports are bonded together in the bond0 device. A
bonded device can contain two or more ports.
All ports associated with a bond must have the same link speed (1GbE or 10GbE).
3. For each bonded device, specify the bonding mode: