Quantum DXi6900

Chapter 3: Remote Management
Accessing Remote Management
Quantum DXi6900 User’s Guide 66
Figure34:Login Window
If the Login window does not display, verify that the IP address is correct and that the network path to
the DXi6900 is valid. Also verify that you are using a supported Web browser. Then try again. If you are
still unable to access the Login window, contact your administrator.
Note:The default IP address is 10.1.1.1. The IP address can be changed during installation using
the GettingStartedWizard or at a later time on the Network page (see Network on page 305).
3. Select the login type and enter the corresponding password.
l Monitor - Allowed to view information on the DXi6900 remote management console but cannot
make changes.
l Administrator - Allowed to view and change information on the DXi6900 remote management
console.
l Service - Allowed to view and change information on the DXi6900 remote management console.
Password changes are not allowed.
l LDAP/AD - Allows users assigned system access through a Lightweight Directory Access Protocol
(LDAP) or Active Directory (AD) server to log into the DXi6900 remote management console.
LDAP/AD must be enabled on the LDAP/AD page for this login type to appear (see LDAP/AD on
page 330).
Note:Passwords are limited to 32 characters. Alphanumeric characters and special characters
are allowed. Passwords can be changed on the AccessControl page (see Security on page
318).
4. Click Login.
5. If you log in as a user assigned to the Admin role (local or LDAP) and there were previous unsuccessful
DXi6900 logins, a dialog box appears indicating the previous number of unsuccessful login attempts for
both the current account and all accounts on the DXi6900(see Figure 35 on the next page).
l Click OK to continue.
l Click ViewAdminLog to access the AdministrativeActivityLog page (see Activity Log on page