To Next Page

To Previous Page

M10 Hardware Design

M10_HD_V3.0 - 9 -

1. Introduction

This document defines the M10 module and describes the hardware interface of M10 module

which are connected with the customer application and the air interface.

This document can help customer quickly understand module interface specifications, electrical

and mechanical details. Associated with application notes and user guide, customer can use M10

module to design and set up mobile applications easily.

1.1. Related documents

Table 1: Related documents

SN Document name Remark

[ 1] M10_ATC AT comma n d s s e t

[2] ITU-T Draft new

recommendation V.25ter

Serial asynchronous automatic dialing and control

[3] GSM 07.07 Digital cellular telecommunications (Phase 2+); AT

command set for GSM Mobile Equipment (ME)

[4] GSM 07.10 Support GSM 07.10 multiplexing protocol

[5] GSM 07.05 Digital cellular telecommunications (Phase 2+); Use of

Data Terminal Equipment – Data Circuit terminating

Equipment (DTE – DCE) interface for Short Message

Service (SMS) and Cell Broadcast Service (CBS)

[6] GSM 11.14 Digital cellular telecommunications (Phase 2+);

Specification of the SIM Application Toolkit for the

Subscriber Identity module – Mobile Equipment (SIM –

ME) interface

[7] GSM 11.11 Digital cellular telecommunications (Phase 2+);

Specification of the Subscriber Identity module – Mobile

Equipment (SIM – ME) interface

[8] GSM 03.38 Digital cellular telecommunications (Phase 2+);

Alphabets and language-specific information

[9] GSM 11.10 Digital cellular telecommunications (Phase 2); Mobile

Station (MS) conformance specification; Part 1:

Conformance specification

[10] GSM_UART_AN UART port application notes

[11] M10_HD_AN01 M10 hardware design application notes

[12] GSM_FW_Upgrade_AN01 GSM Firmware upgrade application note

[13] M10_EVB_UGD M10 EVB user guide application notes

Quectel M10 Hardware Design

Other manuals for Quectel M10