Quectel RM510Q-GL - Configuration Pins

5G Module Series
RM510Q-GL Hardware Design
RM510Q-GL_Hardware_Design 52 / 88
4.7. Antenna Tuner Control Interface
ANTCTL[1:2] and RFFE interface are used for antenna tuner control and should be routed to an
appropriate antenna control circuit. More details about the interface will be added in the future version of
this document.
Table 27: Pin Definition of Antenna Tuner Control Interface
1)
If customers have this function requirement, please contact us for more details.
4.8. Configuration Pins
The module provides four configuration pins, which are defined as below.
Table 28: Configuration Pins List of M.2 Specification
Table 29: Definition of Configuration Pins
Pin No.
Pin Name
I/O
Description
DC Characteristics
56
RFFE_CLK*
1)
DO
Used for external MIPI IC control
1.8 V
58
RFFE_DATA*
1)
IO
Used for external MIPI IC control
1.8 V
65
RFFE_VIO_1V8
1)
PO
Power supply for antenna tuner
1.8 V
61
ANTCTL1*
DO, PD
Antenna Control GPIO
1.8 V
63
ANTCTL2*
DO, PD
Antenna Control GPIO
1.8 V
Config_0
(Pin 21)
Config_1
(Pin 69)
Config_2
(Pin 75)
Config_3
(Pin 1)
Module Type and
Main Host Interface
Port
Configuration
NC
GND
NC
NC
Quectel defined
2
Pin
No.
Pin Name
I/O
Description
DC Characteristics
21
CONFIG_0
DO
Not connected internally
-
NOTE