17
PRODUCT CARE & MAINTENANCE
Your Quest metal detector was built to provide years of trouble-free operation but there are a few simple
things that you can do to ensure it continues to operate without issue year-after-year.
Do not wrap the coil cable too tightly around the shaft as adjusting the coil can pull on the cable damaging
the wire or the connection
Do not store the device where prolonged exposure to extreme temperatures can occur to avoid damaging
the electronics. Leaving it in a car during the summer or winter should be avoided for this reason.
Never use a hard or sharp object to operate the touchpads or damage may result. This can also penetrate
the touchpad allowing it to leak when submerged.
Avoid chemical cleaners, solvents, and insect repellents that can damage plastic components and
finishes.
Secure the weather cap tightly to prevent damage to the USB port or allow moisture / sand to enter it
when in the field.
Even small amounts of moisture can cause corrosion of the electrical contacts when connected to a
charger – ensure it is dry before starting the charging process.
If you are storing the detector for an extended period of time, recharge the internal battery every few
months
The Q30 / Q30+ is fully submersible. When you take it out of the water, rinse it and your waterproof
headphones (if attached) with fresh water to remove any sand or salt which can cause problems if allowed
to buildup.
The detector itself is fully waterproof; however, the wireless headphones are not. DO NOT take them in
the water as it will damage the internal electronics.
Periodically remove the coil cover on the bottom of the coil to remove any dirt, sand or salt that has
accumulated inside. Excessive buildup of salt or sand can cause erratic operation of the detector.
CLEAN YOUR DETECTOR WHEN YOU GET HOME
Turn off the detector before you start to wipe it down
Disassemble the shafts and flush dirt / sand from inside the shafts as well as the camlocks
Rinse it with fresh water (not the wireless headphones)
Wipe the device using a damp cloth using nothing more than a mild detergent solution
Gently wipe the screen with the cloth
Wipe it dry with soft, clean, lint-free cloth.
Allow the device to dry completely before reassembling it
To Next Page
General
