Before first use, it is recommended that you fully charge the battery for 6 hours. Use a high-
quality mobile phone charger plug to charge the detector. The specific steps are as follows:
Remove the charging cable, unscrew the protective cap of the detector, insert the larger end
of the charging cable into a socket or a computer with a standard plug, or a solar power
bank, and insert the smaller end (Type-C) into the metal detector plug
Apply LCD screen protective film
1. Take off the thin plastic covering from the detector's screen. Check that there's no dust
or fingerprints on the screen."
2. Carefully remove the protective backing from the screen protector."
3. Hold the screen protector by its edges, line it up with the screen, and gently place it
down.If there are any bubbles, use a soft and clean cloth to push them to the edge."
4. Finally, remove the top layer from the screen protector.
To Next Page
Loading...
Need help?
General
