40
11.3 File Programming
Start programming either by entering the file number directly on the “TYPE” key or by pressing the “TYPE”
key without entry and selecting the file from the programming window. At the end of each line the file
number is shown in brackets for reference.
Please note that files, which are not activated in the configuration, will not be shown. The following files
are available:
When the file has been selected, the first record will automatically be displayed. You can jump to another
record by entering the record number on the “Multiplication” key. Pressing the “X” key without entry will
select the next record.
The data field to be programmed can be selected by the cursor keys “PAGE UP”, “CURSOR UP”, “PAGE
DOWN”, “CURSOR DOWN”. When the field is selected just input the new data and confirm with “ENTER”.
When a field was modified, the new programming is automatically printed.
If you want to continue programming files, you may repeat the same steps. To finish the programming
mode press the key “TYPE” without entry.
To Next Page
Loading...
Need help?
General
