Radio Shack PRO-528 - storing frequencies into channels

21
The Basics
storing known frequencies into
channels
You can locate and store specifi c
frequencies into channels for later use.
Note: To store trunked system
frequencies, see “programming
trunked frequencies.”
Follow these steps to store frequencies into
channels.
1. Press E/PGM to put the scanner in
programming mode. PGM appears.
2. Use the number keys to enter the
channel number you want to assign to
a frequency.
3. Press SCAN/MANUAL.
4. Use the number keys and •/CLR /
DELAY to enter the frequency, including
the decimal point you want to store.
5. Press E/PGM to store the frequency
into the channel.
Notes:
• If you entered an invalid frequency
in Step 4, Error appears and the
scanner beeps error tones.
Enter a valid frequency.
Notes
Notes