74
Beyond the Basics
selecting a preset fl eet map
1. Set the scanner for conventional
scanning and press E/PGM, then
press TRUNK to select the trunking
programming mode and the bank you
want to change.
2. Repeatedly press S or T to select
TYPE 1 SYSTEM (E1), then press E/
PGM.
3. Repeatedly press S or T to select
FLEEt, then press E/PGM.
4. Repeatedly press S or T to select the
name of the desired map (example
E1P7). The preprogrammed fl eet map
appears.
5. Press E/PGM. FLEEt displays.
Note: When the scanner searches
for transmissions, Type I fl eet and
subfl eet IDs such as 100-12, 100-9,
000-12, or 400-8 display.
If you are still unable to listen to a complete
conversation, then try another preset map.
programming a fl eet map
1. Select the trunking programming mode
and the bank you want to change.
2. Repeatedly press S or T to select Type
1 System (E1), then press E/PGM.
Notes
To Next Page
Loading...
