80
Beyond the Basics
frequently asked
questions
These suggestions might help you locate
the problem.
My scanner is on but will not
scan, why?
• SQUELCH is not adjusted correctly;
adjust SQUELCH.
• Only one channel or no channels are
stored.
• Store frequencies into more than one
channel.
Why won’t my scanner work at
all?
• Check the batteries or make sure the
AC adapter or DC adapter is connected
properly.
• Recharge the rechargeable batteries or
replace the non-rechargeable batteries.
• The AC adapter or DC adapter is not
connected.
• Be sure the adapter’s barrel plug is
fully plugged into the 9V 300 mA jack.
To Next Page
Loading...
