29
Beyond the Basics
Note: You cannot skip frequencies
during WX service search.
To skip a frequency, press L/O when the
scanner stops on the frequency during a
chain, direct and service search and Signal
Stalker I. The scanner stores the frequency
in memory and automatically resumes the
search.
To clear a single frequency from skip
memory so the scanner stops on it during a
chain, direct and service search and Signal
Stalker I:
1. Press HOLD/RESUME to stop the
search.
2. Press S or T to select the frequency.
L/O appears.
3. Press L/O. L/O disappears.
To clear all the skip frequencies at once
while searching, press HOLD/RESUME,
then hold down L/O until the scanner
beeps twice.
Notes:
• If you selected all frequencies to be
skipped within the search range,
the scanner beeps 3 times and
does not search.
• If you select more than 200
frequencies to skip, each new
frequency replaces a frequency
Notes
To Next Page
Loading...
