55
Beyond the Basics
depending upon the trunk system
selected.
Notes:
• If you enter an invalid frequency
(outside the selected range),
the scanner beeps, the channel
number fl ashes and Error appears.
If this happens, press •/CLR /
DELAY to clear the frequency, then
repeat the entry.
• For EDACS (Ed) and LTR systems,
you must enter the frequencies
in logical channel number (LCN)
order.
• If you try to enter a duplicate
frequency in a bank, the scanner
beeps and the channel which was
previously stored appears
5. Press S or T to select the next
channel in the bank and repeat Step 4
to enter frequencies in that bank.
6. Repeatedly press •/CLR /DELAY to
return back to Step 2. Repeat Steps 2
and 5 until all frequencies have been
entered.
7. Press SRCH to begin searching for
the trunk’s data channel and scan
conventional frequencies at the same
Notes
To Next Page
Loading...
