Radio Shack REALISTIC PRO-2042 - Storing and Searching Frequencies

• If you turn TUNING too slowly, the
scanner might accidentally
change the search or scan direc¬
tion.
Follow these steps to use the rotary
tuner to tune frequencies.
1. When the scanner stops on a fre¬
quency while searching, press
TUNE. The frequency number and
TUNE appear.
2. To tune frequencies, turn TUNING
clockwise (to tune to higher fre¬
quencies) or counterclockwise (to
tune to lower frequencies).
USING MONITOR
MEMORIES
Monitor memories are temporary sto¬
rage areas where you can store up to
100 frequencies while you decide
whether or not to save them into chan¬
nels. You can manually select monitor
memories, but you cannot scan them.
You can store frequencies you find
during a limit or direct search, or while
tuning, into monitor memories. Simply
press MONITOR when the desired fre¬
quency appears on the display. The
channel number to the right of MON in¬
dicates the current monitor memory.
To listen to a monitor memory, press
MANUAL, then press MONITOR. The
current monitor memory appears. To
select other monitor memories, either:
• Turn TUNING one click to select
each monitor memory.
• Use the number keys to enter the
monitor memory’s number, then
press MONITOR.
Both MON and the frequency stored in
the monitor memory are displayed.
SEARCHING FOR AND
STORING ACTIVE
FREQUENCIES
You can store frequencies into chan¬
nels using any of the following me¬
thods:
• Manual storage
• Auto storage
• Limit search (within a range of pre¬
programmed frequencies or fre¬
quencies you select)
• Direct search (within a range of fre¬
quencies before or after a fre¬
quency you select)
• Moving a frequency from a monitor
memory
19