Radio Shack REALISTIC PRO-2042 - Changing a Preprogrammed Range

Notes:
• You can search more than one
limit search range at a time. For
example, if you want to search
both the 25-29.995 MHz and
68-87.495 MHz ranges, press
2, then press 4.
• To select bank 10, press 0.
1. Press A to search from the lower
to the upper limit, or ^ to search
from the upper to the lower limit. As
the scanner searches, it displays
SEARCH, and the bar under the
selected search bank number
flashes.
When the scanner finds an active
frequency, it stops searching. To
save the frequency into a monitor
memory, press MONITOR. MON
and the current monitor channel
number appear on the display.
Press A or V again to continue
searching for additional active fre¬
quencies.
Notes:
■ As the scanner automatically
searches, you can also search
through frequencies manually by
pressing TUNE, then turning TU¬
NING. Press TUNE again to con¬
tinue the limit search.
• During limit search, you can ma¬
nually change the band mode or
frequency step. See “Changing/Re¬
setting the Band Mode” or “Chan¬
ging/Resetting the Frequency
Step” on Page 35.
Changing a Preprogrammed
Range
You can replace preprogrammed limit
search ranges with frequency ranges
you enter. This is useful if there is a
range of frequencies you search often
that is not within any of the prepro¬
grammed ranges.
Note: You can restore prepro¬
grammed limit search ranges you re¬
placed by resetting the scanner. See
“Restarting/Resetting the Scanner” on
Page 9.
1. Press PROGRAM. PROGRAM ap¬
pears.
2. Using the number keys, press the
number for the preprogrammed
limit search range you want to
change.
Note: To select bank 10, press 0.
3. Press LIMIT, search bank and
ho appear, and a bar flashes under
the selected search bank’s number.
Note: If you already entered your
own limit search ranges in other
search banks, a bar appears under
each of those search bank num¬
bers.
4. Use the number keys to enter the
lower limit of the frequency range
you want to search, then press
ENTER.
24