Radio Shack REALISTIC PRO-2042 - Search Mode Functions

LIMIT SEARCH
You can search for transmissions with¬
in a range of frequencies you select,
called a limit search range. You can ei¬
ther use one of the scanner’s 10 pre¬
programmed limit search ranges, or
you can enter your own.
Notes:
• You can use the scanner's delay
feature while using limit search.
See “Delay” on Page 31.
• When the scanner searches for fre¬
quencies within a limit search
range, you can store frequencies
you hear during the search into
monitor memories.
• The scanner does not search
locked-out frequencies during limit
search unless the locked-out fre¬
quency is the upper or lower limit
frequency.
Searching a Preprogrammed
Frequency Range
The scanner contains these prepro¬
grammed limit search ranges, stored in
search banks (1-10).
Search
Bank
Limit Search
Range (MHz)
1
25-1300
2
25-29.995
3
30-67.995
Search
Bank
Limit Search
Range (MHz)
4
68-87.495
5
87.5-107.95
6
108-136.9875
7
137-224.995
8
225-400
9
400.0125-520
10
760-1300
Note: You can replace a prepro¬
grammed range (see “Changing a Pre¬
programmed Range” on Page 24).
Follow these steps to select prepro¬
grammed limit search ranges and
search them for active frequencies.
1. Press LIMIT. L and the number of
the currently selected search banks
appear, and a bar flashes under
each of those search bank num¬
bers.
Note: If you already entered your
own limit search ranges in other
search banks, a bar appears under
each of those search bank num¬
bers.
2. Using the number keys, enter the
search bank number for each limit
search range you want to select or
remove.
23