Radio Shack REALISTIC PRO-2042 - Page 22

6. Use the number keys to enter the
upper limit of the frequency range
you want to search, then press
ENTER.
7. Press A to search from the lower
to the upper limit, or V to search
from the upper to the lower limit.
AUTO and the bar under the cur¬
rently selected bank number flash
on the display.
When the scanner finds an active
frequency, it stores the frequency in
the displayed channel, then conti¬
nues searching for more active fre¬
quencies, storing them in any
subsequent empty channels. When
the scanner fills all channels within
the selected banks, the scanner
beeps rapidly and displays the
number of the last channel where a
frequency was stored.
Note: During auto store, you can
manually change the band mode or
frequency step. See “Changing/
Resetting the Band Mode” or
“Changing/Resetting the Frequen¬
cy Step” on Page 35.
To pause auto store, press AUTO.
The scanner displays the last chan¬
nel number where a frequency was
stored. To continue auto store,
press A or V.
8. To stop auto store, press MANUAL.
MANUAL appears.
Notes:
• If no frequencies are stored when
you pause auto store by pressing
AUTO,-appears on the display.
• During auto store, the scanner
beeps when the search reaches the
upper limit frequency and continues
searching at the lower limit fre¬
quency, or vice versa.
• If you set the limit range (in Steps 3-
6) equal to or narrower than the fre¬
quency step of the band mode, the
scanner beeps continuously.
22