Radio Shack REALISTIC PRO-2042 - Direct Search

Note: If you enter an invalid fre¬
quency in Step 4 or 6, the scanner
displays Error. Simply repeat
the step.
5. Press LIMIT. SEARCH BANK and
Hi appear.
6. Use the number keys to enter the
upper limit of the frequency range
you want to search, then press
ENTER. The scanner replaces the
preprogrammed limit search range
with the range you selected.
Notes:
• To review your limit search
ranges, turn TUNING one click
for each search bank. A bar
flashes under the selected
search bank number, and either
Lo or Hi appears. Press LIMIT
to review the high and low limits
of the frequency range for the
selected search bank.
• If the limit search range is nar¬
rower than the frequency step,
-PASS- appears on the dis¬
play and the scanner does not
search. To correct this, either
press STEP to change the fre¬
quency step (see “Changing/
Resetting the Frequency Step"
on Page 35) or enter a wider
frequency range in Steps 4 and
6 .
DIRECT SEARCH
You can search up or down from the
currently displayed frequency and
store frequencies you like into monitor
memories.
Notes:
• You can use the scanner’s delay
feature while using direct search.
See “Delay” on Page 31.
• The scanner does not search
locked-out frequencies during
direct search.
1. Press MANUAL or PROGRAM.
2. Use the number keys to enter the
frequency you want to start the
search from. Or, use the number
keys to enter the channel number
containing the starting frequency
and press MANUAL or PROGRAM
again.
25