Radio Shack REALISTIC PRO-2042 - Moving Frequencies; Moving a Frequency from a Monitor Memory to a Channel; Moving Frequencies from Monitor Memories to a Bank

• You can manually select any chan¬
nel in a bank, even if the bank is
turned off.
To turn on banks while scanning, press
the bank’s number key until a bar ap¬
pears under the bank’s number.
MOVING FREQUENCIES
Moving a Frequency from a
Monitor Memory to a Channel
1. Press PROGRAM.
2. Use the number keys to enter the
channel number where you want to
store the monitor frequency, then
press PROGRAM.
3. Press MONITOR. MON flashes. Use
the number keys to enter the moni¬
tor memory’s number, then press
MONITOR. Or, turn TUNING to
select the monitor memory's num¬
ber.
MON flashes and the monitor me¬
mory’s number and frequency
appear.
4. Press ENTER. The scanner stores
the frequency in the selected chan¬
nel.
5. To move another monitor memory
frequency to the next channel, turn
TUNING to select the next channel
and repeat Steps 3-4.
Moving Frequencies from
Monitor Memories to a Bank
Your scanner can move all the fre¬
quencies you have stored in monitor
memories into a bank you specify.
Notes:
• If there are more frequencies in
the monitor memories than there
are empty channels in the bank
you select, the scanner moves
only as many frequencies from the
monitor memories as it has room
for in the bank, leaving the
remaining frequencies in the mo¬
nitor memories.
• The scanner programs monitor
memory frequencies into channels
even if the same frequencies are
already programmed into other
channels.
1. Press AUTO, auto appears.
2. Using the number keys, press the
bank number where you want to
store monitor memory frequencies.
If you select a bank that contains at
least one empty channel, a bar
flashes under the bank number,
and AC-, the number of empty
channels in the bank, ch, and
AUTO appear.
Notes:
• To select bank 10, press 0.
• If you do not want to select the
bank, press the bank’s number
again.
27