Radio Shack REALISTIC PRO-2042 - Notices and Preparation; Interference Warnings

NOTICE
Your scanner might cause TV or radio
interference even when it is operating
properly. To determine whether or not
your scanner is causing the interfe¬
rence, turn off your scanner. If the in¬
terference goes away, your scanner is
causing it. Try to eliminate the interfe¬
rence by:
• Moving your scanner away from the
receiver.
• Connecting your scanner to an out¬
let that is on a different electrical cir¬
cuit from the receiver.
• Contacting your local Tandy store
for help.
If you cannot eliminate the interfe¬
rence, local regulations may require
you to stop using your scanner.
For U.K. Only
The supplied appliance is fitted with an
approved 13 Amp standard UK type
plug. If this plug is not compatible with
your mains socket outlet it should be
cut off and disposed of immediately as
it is a shock hazard if inserted into a
live socket outlet. An approved type
plug that is compatible with your sock¬
et outlets must then be fitted.
Important: The wires in the mains
lead are coloured in accordance with
the following codes:
Blue.Neutral
Brown.Live
The wires in the mains lead must be
connected to the terminals in the plug
as folows:
Mains Lead Plug
Wire Colour Terminal
Marking
Blue.N or Black or Blue
Brown.L or Red or Brown
Do not connect either wire to the earth
terminal marked or by the letter E or by
the safety earth symbol ( -4=- ) or co¬
loured green or green-and-yellow.
If the plug required for your socket out¬
lets is fitted with a fuse, this must be a
3 Amp type and should carry BS kite or
ASTA mark.
Never use a plug without a fuse cover
fitted.
If the plug is not fusible type, the mas¬
ter fuse for the mains outlet sockets
should not be greater than 5 Amps.
If in doubt refer to a qualified electri¬
cian.
Warning: This equipment should be
disconnected when not in use for an
extended period.
4