CT100 Operation Guide
Customization
Menu Screen Functions
Swing (HVAC Cycling Rate)
This feature enables you to set the acceptable variance in
temperature between the CT100’s setting and the current room
temperature before the heating or cooling system will turn on. The
Swing range can be from 0.5 to 4.0F (.25 to 2C). For example, if Swing
is set to 2.0°F and the CT100 is set to 70°F target temperature, the
heat cycle will start when the room temperature drops to 68°F.
Similarly, the cooling system will start when the room temperature
increases to 72°F. The HVAC runs until the room reaches the target
temperature, and then shuts off .
To set Swing
1. From the Menu screen, touch Swing.
2. Touch Time Adjustment arrows to set the SWING from 0.5°
to 2.0°F. The HVAC will run more frequently at .5°F and less
frequently at 2°F. The default is 1°F.
3. Touch
to return to the Menu screen.
Set Time Of Day
• Touch arrows to set the current time.
• Touch and hold an arrow to move in 15 minute increments.
Set Fº or Cº
• Toggle between the ºF, ºC to switch back and forth
Sound
When enabled, the chirp sounds when you
change to a new screen or change a setting.
Filter
To help you remember to replace your air fi lters, use the fi lter
replacement reminder count-down (in days). Setting this value to 0
disables the reminder.
Menu Screen
The Menu provides access to many features and settings of the CT100.
Features you can control on the Menu screen are ºF / ºC setting,
thermostat calibration, fi lter replacement reminder, and more. The
following pages provide detailed function settings.
Sound On
Sound Off
39
To Next Page
Loading...
Need help?
General
