EasyManuals Logo

Radio Thermostat CT100 User Manual

Radio Thermostat CT100
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Getting Started
Installation Guide CT100
Tools Needed
Small Phillips screwdriver
Drill with 3/16- in.(4.8mm) bit
To avoid electrical shock and to prevent damage to the
furnace, air conditioner, and thermostat, disconnect the power
supply before installing or servicing the thermostat or any part
of the system. This can be done at the circuit breaker.
Do not reconnect electricity until work is complete.
Do not short (jumper) across electric terminals at the control
on the furnace or air conditioner to test the system. This can
damage the thermostat.
Your thermostat is a precise instrument. Handle it with care.
All wiring must conform to local codes and ordinances.
This thermostat is designed for use with 4AA alkaline batteries
and/or 24- volt AC C wire (or a 12- 24 AC or DC source) and
millivolt gas systems. Each thermostat relay load should be
limited to 1.0 amp; higher amperage can cause damage to the
thermostat.
!
CAUTION
4

Other manuals for Radio Thermostat CT100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Radio Thermostat CT100 and is the answer not in the manual?

Radio Thermostat CT100 Specifications

General IconGeneral
BrandRadio Thermostat
ModelCT100
CategoryThermostat
LanguageEnglish

Related product manuals