Raidon SR6600 Series - Physical Drive Management

2.4.1.5 Tagged Queuing
Enabling this function will offer more stable performance between systems. Please turn off this function if
your SCSI card does not support Command Tag Queuing.
2.4.1.6 IDE Channel
You can choose which interface to use for data transfers:
•Channel0:IDEInterface
•Channel1:SATAInterface
2.4.1.7 IDE Xfer Mode
SupportforATA133,ATA100,ATA66andATA33.ThisismainlyusedtoconguretheinternalRAID
controller.
2.4.2 Delete Volume Set
This function can be used to delete the existing volume set.
2.4.3 Modify Volume Set
Thisfunctioncanbeusedtore-deneormodifyavolumeset’sattributes.
2.4.4 Check Volume Set
Use this function to check the consistency of the volume set.
2.4.5 Stop Volume Set Check
Stop the volume set consistency check currently in progress.
2.5 Physical Drive
This function shows all of the physical drive related information including:
•CreatePassThroughDisk
•ModifyPassThroughDisk
•DeletePassThroughDisk
•IdentifytheDevice
2.5.1 Create Pass Through Disk
This HDD will not be added to the RAID set and will be treated as an independent disk drive by the
operating system. Once this HDD has been set up, the hardware information will be shown.
26 System Management