Raidon SR6600 Series - System Controls and Settings

2.5.2 Modify Pass Through Disk
ThisfunctioncanbeusedtomodifythesettingsforthecurrentPassThroughDisk.Oncemodiedthe
hardware information will be shown.
2.5.3 Delete Pass Through Disk
ThisfunctioncanbeusedtodeletethecurrentlydenedPassThroughDisk.
2.5.4 Identify Device
To avoid the removal of the wrong HDD, this function can be used to check that the correct HDD is
currently selected. Select this function then select the HDD to remove. The LED light for the selected
HDD will begin to blink.
2.6 System Controls
The RAID System functions offer the following setup options:
•SystemCong
•EtherNetCong
•AlertByMailCong
•SNMPConguration
•NTPConguration
•ViewEvents/MuteBeeper
•GenerateTestEvent
•ClearEventBuffer
•ModifyPassword
•UpgradeFirmware
•RestartController
2.6.1 System Cong
Click this feature will enter to advanced access device-related settings.
2.6.2 EtherNet Cong
ThisfunctioncanbeusedtoconguretheEthernetsettings,including:DHCPFunction,LocalIPAddress,
HTTP Port Number, Telnet Port #, SMTP Port Number and Ethernet Address.
2.6.3 Alert By Mail Cong
Click this function to set alert by mail.
2.6.4 SNMP Conguration
This function can be used to setting related web management.
System Management 27