ESP-2WIRE Controller
16
SUPPLIER’S DECLARATION OF CONFORMITY
47 CFR § 2.1077 Compliance Information
Unique identifi er: ESP-2WIRE
Responsible Party - Rain Bird Corporation, 9491 Ridgehaven Court,
Suite C, San Diego, CA 92123, USA, www.rainbird.com
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit diff erent
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Rain Bird Corporation, 6991 East Southpoint Road, Tucson, AZ 85756,
USA, www.rainbird.com
Registered trademark of the Rain Bird Corporation
2024 Rain Bird Corporation
NOTICE
• Changes or modifi cations not expressly approved by Rain Bird
could void the user’s authority to operate the equipment.
• Use only Rain Bird approved accessory devices. Unapproved devic-
es may damage the controller and void warranty.
• Date and time are retained by a lithium battery which must be
disposed of in accordance with local regulations.
WARNING
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capacity, or
lack of experience and knowledge unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised
to ensure that they do not play with the appliance.
• If the supply cord is damaged, it must be replaced by the manu-
facturer, its service agent, or similarly qualifi ed persons in order to
avoid a hazard.
• If the power supply unit is damaged, it must be replaced by the
power supply unit available from the manufacturer or its service
agent.
• Special precautions must be taken when valve wires are located
adjacent to, or share a conduit with other wires, such as those used
for landscape lighting or other electrical systems.
• Separate and insulate all conductors carefully, taking care not to
damage wire insulation during installation. An electrical “short”
(contact) between the valve wires and another power source can
damage the controller and create a fi re hazard.
This controller uses a non-replaceable lithium battery.
Lithium batteries are hazardous and can cause severe or fatal
injuries in 2 hours or less if it is swallowed or placed inside
any part of the body. Medical attention should be sought
immediately if this is suspected. Keep batteries away from
children.
• DO NOT apply power until you have completed and checked all
wiring connections.
• DO NOT attempt to link two or more controllers together using a
single transformer.
CAUTION
• Only use the provided power supply unit. It provides the voltage
required by the controller.
• All electrical connections and wiring runs must comply with local
building codes. Some local codes require that only a licensed or
certifi ed electrician can install power. Only professional personnel
should install the controller. Check your local building codes for
guidance.
To Next Page
Loading...
