To Next PageTo Next Page
Need help?Do you have a question about the Rain Bird ESP-2WIRE and is the answer not in the manual?
General| Brand | Rain Bird |
|---|---|
| Model | ESP-2WIRE |
| Category | Controller |
| Language | English |
Details the features and capabilities of the ESP-2WIRE controller, including station capacity and supported functions.
Enables remote connection to the controller via a smartphone app using the LNK2™ WiFi Module.
Provides steps for removing an old controller and preparing for the new installation.
Instructions on how to physically mount the controller unit securely on a wall.
Details the electrical wiring connections for a 120V power supply to the controller.
Introduces the 2-Wire path connection capabilities of the ESP-2WIRE controller.
Guides through the process of installing new decoders in a 2-Wire system, including address assignment.
Explains how the Master Valve address is assigned in a 2-Wire system configuration.
Instructions on how to apply decoder barcode labels to the programming chart.
Guidance on entering station and run time information into the programming chart.
Details the wiring process to connect 2W-1 Decoders to the main 2-wire path and valve solenoids.
Describes how to route and connect field wires to the controller terminals.
Explains the automatic feature to find and assign station numbers to decoders.
Steps to remove or clear an assigned decoder address for a specific station.
Procedure to modify the decoder address assigned to a particular station.
Details how swapping addresses between two stations affects their assignments.
Instructions for replacing existing decoders and repopulating addresses using the auto-address function.
Procedure for adding new decoders to an existing 2-Wire system and assigning them addresses.
Steps to clear all existing decoder addresses and re-run the auto-addressing process.
An overview of the controller's dial configuration and button layout for various functions.
Explains the meaning of various symbols and messages displayed on the controller screen.
Describes the normal operating mode where the controller waters automatically based on programmed schedules.
Explains how to turn off automatic irrigation and cancel all active watering.
Initiates immediate watering for all programmed stations for testing purposes.
Allows manual watering for a single selected station or multiple stations in sequence.
Starts immediate watering for a single selected program.
Sets watering to occur at specific intervals, like every 2 or 3 days.
Configures watering to run on all odd or even calendar days.
Adjusts program run times by a percentage, from 5% to 200%.
Suspends watering for a specified period, up to 14 days.
Prevents watering on specific days of the week for certain programming types.
Instructions for connecting rain sensor wires to the controller's sensor terminals.
Instructions for connecting flow sensor wires to the controller's flow terminals.
Saves current programming settings for later restoration.
Guides on finding and correcting faults or solving problems with the controller.
Restores the controller's programming from a previously saved state.
Allows a specific station to be controlled by a master valve or pump start relay.
Configures watering to occur on all ODD or EVEN calendar days for selected programs.
Determines if a station obeys or ignores a connected rain sensor.
Enables or disables a flow sensor's operation on a per-station basis.
Resets all programmed schedules and settings to the controller's factory defaults.
Sets a delay between stations to ensure valve closure before the next station starts.
Instructions on how to use the reset button to restart the controller.
Information about connecting external devices like the LNK2™ WiFi Module.
Steps for installing the LNK2™ WiFi Module into the controller's accessory port.
FCC compliance information and declarations regarding the device's performance and safety.
