PRODUCT INSTALLATION
INSTALLING THE BATTERIES
1. Remove the batte tray on the back of the timer.
2. Inse 2 new AA (1.5V) alkaline batteries (not included).
3. Put the batte tray back on the timer and press rmly to
make sure it is completely sealed.
BATTERY STATUS
Batte Status will be displayed as following:
Full Power Low Power
Note:
Note:
When the low batte indicator appears on display, the valve will close
automatically to avoid leakage. Please replace the batte in time in case of
interrupting the normal operation.
1. Install the batte tray securely after
installing the batte to ensure
waterproong.
2. When the timer is not used for a long
time, please remove the batteries and
dispose of them properly.
3. Replace batteries when the low batte
indicator appears on display. After
you done it, please remember to reset
your watering plans.
4. Don’t dispose of batteries in re.
Batteries may explode or leak.
5. To ensure a longer lifespan, please use
2 new AA alkaline batteries
(not included). Don’t mix new and old
alkaline, standard (carbon-zinc), or
rechargeable batteries.
- 04 -
To Next Page
Loading...
Need help?
General
