13/21
R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
5.2.2 Control selection
The control selections are located below the LCD display. The control selections:
The control DIR1 indicates that the motor is rotating forward.
The control DIR2 indicates that the motor is rotating backward.
The control I/O indicates that the I/O terminal block is the selected control place.
The control BUS1 indicates that the fieldbus is the selected control place (BUS1).
The control BUS2 indicates that the fieldbus is the selected control place (BUS2).
The control is selected when an arrow is pointing towards the corresponding text. For example, when the motor is
rotating forwarding, an arrow is shown above the text DIR1.
5.2.3 Main menu
The content of the main menu is described in the following section.
To Next Page
Loading...