R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
P.: (937) 328-5100
7/21
R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
2 SAFETY FIRST!
Safety requirements must be understood and followed.
2.1 Fire Safety
In the event of a fire, only attempt to fight it if you can do so without putting yourself in danger. Turn the power off if
it
is possible to do so. Evacuate the area. Notify other people about the potential danger, and call for help.
WARNING
Never use a powder type fire extinguisher on high voltage.
2.2 Main Isolation Switch
The product can only be driven when power is turned on. The owner must identify and document the location and
function of the main isolation switch and must communicate this information to all operators.
CAUTION
Owner/Operator shall be aware of main isolation switch functionality. Even
though one switch is turned off, there may still be voltage present in some
parts of the product. This may result in exposure to electric shocks.
The operator shall not operate the product unless he or she knows the location
of the main isolation switch.
Avoid turning off the main isolation switch during load movement. Sudden loss
of power may cause the load to swing and cause serious damage to the
product, personnel or load.
When the main isolation switch is turned on after being placed in the off position, the set-up procedure must be
followed before the product can be used.
2.3 Emergency Stop
In the event of a equipment malfunction or other emergency situation, all motions can be stopped immediately by
pressing the red emergency stop button located on the controller. In normal operation, the emergency stop button
should not be used instead of making proper use of the direction controls. Routinely using the emergency stop
button increases wear on the product and can cause the load to swing.
To Next Page
Loading...