Measuring Procedure
R&S
®
RT-ZC31
25User Manual 1801.4949.02 ─ 01
Measuring low currents
●
To measure DC or low-frequency current, multiple windings may be
used to increase relative sensitivity (10 windings multiplies the mea-
sured current by a factor of 10). However, in this case, the windings
should be made radially, with a diameter of at least 20 cm.
●
Cord placement and the act of clamping the probe onto the conductor
being measured may trigger load fl uctuations, affecting the observed
waveform.
Connecting the Probe to the DUT
To Next Page
Loading...
