Preparing for Use
R&S
®
SMA100B
20Getting Started 1419.8620.02 ─ 07
4.2 Connecting USB Devices
The USB interfaces of the R&S SMA100B allow you to connect USB devices,
including USB hubs directly to the instrument. Due to the large number of availa-
ble USB devices, there is almost no limit to the expansions that are possible with
the R&S SMA100B.
The following list shows various USB devices that can be useful:
●
Memory stick for easy transfer of data to/from a computer (for example firm-
ware updates)
●
Keyboard or mouse to simplify the entry of data, comments, filenames, etc.
●
Power sensors of the R&S NRP families
All USB devices can be connected to or disconnected from the instrument during
operation.
Connecting a USB storage device
When a USB storage device like a memory stick, a CD-ROM drive, or a hard disk
is connected, it is detected automatically. The device is made available as a new
drive (/usb). The name of the drive is manufacturer-dependent.
Connecting a keyboard
A keyboard is detected automatically when it is connected. The default keyboard
layout is English – US.
Connecting a mouse
A mouse is detected automatically when it is connected.
4.3 Setting Up a Network (LAN) Connection
The R&S SMA100B is equipped with a network interface and can be connected
to an Ethernet LAN (local area network). Provided the appropriate rights have
been assigned by the network administrator, the interface can be used, for exam-
ple:
●
To transfer data between a controller and the instrument, for example to run a
remote control program.
Setting Up a Network (LAN) Connection