Need help?Do you have a question about the R&S SMW200A and is the answer not in the manual?
General| Brand | R&S |
|---|---|
| Model | SMW200A |
| Category | Portable Generator |
| Language | English |
Describes basic steps for setting up the R&S SMW for the first time.
Explains how to connect the instrument to AC power and its characteristics.
Details the procedure for turning the R&S SMW on and off.
Explains how to connect USB devices like memory sticks, keyboards, and mice.
Describes how to configure the LAN interface for network connectivity.
Step-by-step guide to generating a simple unmodulated signal.
Example of generating a WCDMA-3GPP signal with QPSK modulation.
Illustrates external triggering principles and configuration for signal generation.
Explains how to output marker signals for synchronization with external devices.
Covers signal routing capabilities and distributing I/Q streams to output connectors.
Demonstrates using the graphical display to check signal spectra and characteristics.
Details how to save instrument settings to a file and load them later.
Introduces generating EUTRA/LTE signals using test models.
Explains using system configuration for MIMO setups and coupled baseband sources.
Example of generating an EUTRA/LTE signal for MIMO tests on UE.
Example of LTE signals with carrier aggregation and MIMO for UE tests.
Example of generating a WLAN 802.11ad signal with specified bandwidth.
Outlines manual, remote control, and remote operation methods.
To Next Page
