R&S SMW200A - Connectors

Instrument Tour
R&S
®
SMW200A
40Getting Started 1412.9220.02 ─ 21
BBMM
1
8
7
6
3b 9
5
2
4a
3a
4b
654a
3a
2
Figure 5-4: Detail view: Rear panel of instrument equipped with R&S SMW-B9 and
R&S SMW-B13XT (wideband baseband)
1 = R&S SMW-B9, R&S SMW-B13XT and R&S SMW-B15 boards location
2 = Board designation (CODER, BBMM, FADER)
3a, 3b = DIG I/Q connectors (connectors on the FADER board are provided for future use)
4a, 4b = HS DIG I/Q connectors (connectors on the FADER board are provided for future use)
5 = ADV DATA/CTRL connectors
6 = T/M/C and T/M connectors
7 = ADV TRIG and ADV CLK connectors
8 = EXT x connectors
9 = I/Q, I/Q Bar connectors
5.2.1 Connectors
I/Q
Rear panel connectors, recommended for use of the instrument in a 19" rack.
See also "Mounting in a rack" on page 19.
RF A/RF B
Rear panel connectors for the first RF path (option R&S SMW-B81/-B83) and the
second RF path (option R&S SMW-B82/-B84). These options are recommended
for use of the instrument in a 19" rack.
See also "Mounting in a rack" on page 19.
IEC 625/IEEE 488
GPIB-bus interface for remote control of the instrument.
Rear Panel Tour