R&S SMW200A - Generating an Unmodulated Carrier

Trying Out the Instrument
R&S
®
SMW200A
48Getting Started 1412.9220.02 ─ 21
6.1 Generating an Unmodulated Carrier
We start out by generating a simple unmodulated signal. The R&S SMW in this
example can be a base unit in its minimal configuration.
1. On the R&S SMW front panel, press the [PRESET] key to start out in a
defined instrument configuration.
2. Set the frequency:
a) On the "Status Bar", tap the "A Freq" field.
b) On the on-screen keypad, enter 1.955 and press the "GHz" key.
The on-screen key pad closes and the frequency value is displayed.
3. On the "Status Bar", tap the "Lev" field and enter the level in the same way.
4. Select "Block Diagram > RF A Block > On" to enable the output of the gener-
ated unmodulated signal.
Generating an Unmodulated Carrier