R&S SMW200A - Saving and Recalling Settings

Trying Out the Instrument
R&S
®
SMW200A
70Getting Started 1412.9220.02 ─ 21
6.7 Saving and Recalling Settings
To restore the results of our measurements later, we saved the instrument set-
tings to a file.
To save the instrument settings to a file
We assume, a test configuration as described in Chapter 6.5, "Routing the Signal
through the Instrument and Defining the Output Connectors", on page 61.
1. Press the [SAVE/RCL] key on the front panel.
2. In the "Save/Recall" dialog box, select "Operation Mode > Save".
Tap the "Filename", use the on-screen keyboard, and enter MyTestSignal.
Saving and Recalling Settings