R&S SMA100B - Page 20

Preparing for Use
R&S
®
SMA100B
22Getting Started 1419.8620.02 ─ 07
To set up a network (LAN) connection
Risk of network failure
Consult your network administrator before performing the following tasks:
●
Connecting the instrument to the network
●
Configuring the network
●
Changing IP addresses
Errors can affect the entire network.
► Connect the instrument to the network or to a single PC.
If the instrument is connected to the LAN, the operating system automatically
detects the network connection and activates the required drivers.
By default, the instrument is configured to use DHCP (dynamic host configura-
tion protocol) configuration and to obtain the whole address information auto-
matically.
When connected, the R&S SMA100B displays the address information on the
screen.
Risk of network connection failure
Network cables and cable connectors of poor quality, or failures in the auto-
negotiation process, can cause network connection failures.
If the network connection to the instrument fails, check the network infra-
structure and contact your network administrator.
For details, see section "Troubleshooting and Error Messages" in the
R&S SMA100B user manual.
Setting Up a Network (LAN) Connection