Instrument Tour
R&S
®
SMA100B
36Getting Started 1419.8620.02 ─ 07
LF
Output for internal LF generator signal.
See also data sheet and user manual, section "Analog Modulation".
Ext 1/2
Inputs for external analog modulation signal, and an external detector voltage.
AC supply and power switch
The AC power supply connector and the main power switch are located in a unit
on the rear panel of the instrument.
Main power switch function:
●
Position 1: The instrument is in operation.
●
Position 0: The entire instrument is disconnected from the AC power supply.
For details, refer to Chapter 4.1.6, "Turning the Instrument On and Off",
on page 17.
RF
Rear panel connector for the RF signal. This connector is for use of the instru-
ment in a 19" rack.
Rear Panel Tour
To Next Page
Loading...
