R&S SMA100B - Page 40

Trying Out the Instrument
R&S
®
SMA100B
42Getting Started 1419.8620.02 ─ 07
a) Select "Mode > Auto" to run the sweep continuously.
b) Select "Shape > Sawtooth" to set the waveform shape of the sweep signal.
c) Select "Spacing > Linear", to determine the calculation method for the fre-
quency shift of a step.
d) Set "Dwell Time > 15.0 ms", to determine the time interval of the sweep
steps.
5. Select the "Frequency Range" tab.
a) Set "Start Freq > 200 MHz" and "Stop Freq > 600 MHz" to determine the
frequency sweep range.
b) Set the step width "Step Lin > 10.0 MHz" to determine the width for a fre-
quency step.
Generating an RF Frequency Sweep Signal