R&S SMA100B - Page 43

Trying Out the Instrument
R&S
®
SMA100B
45Getting Started 1419.8620.02 ─ 07
Navigate to the directory the file is saved in and select the MyTestSignal
file.
5. Tap the "Recall" button.
All instrument settings are restored and the display resembles Chapter 6.2,
"Generating an RF Frequency Sweep Signal", on page 41, which shows the
instrument display right before the settings were saved.
How to display all parameters with values different to their preset val-
ues
When you load a file to your instrument, you do not have enough informa-
tion on the changed settings. In such case, it is useful to visualize all
parameters that have been changed from their default state.
Try out the following:
●
Touch and hold a spot in the tile diagram for at least 1 second to access the
context-sensitive menu.
●
Select "Mark All Parameters Changed from Preset".
Saving and Recalling Settings