Rane Performer - Using and Changing E Ects

18
8. F
X Assign Buttons: Press these buttons to assign which channel
will receive eects from the associated toggle: Decks 1 or 3 (Left
side) or Decks 2 or 4 (Right side).
Note: FX assignments can only be changed when the eect is
inactive.
9. F
X Depth: Turn this knob to adjust the “wet-dry” mix of the eects
on the corresponding deck. For some eects, this will also change
the value of parameters that are also controlled with the Depth
knob.
Using and Changing Effects
PERFORMER features internal hardware FX and
control over software FX. Both internal and software
Main FX are all post-fader. Channel FX from software
are pre-gain, EQ, and channel fader.
1. Press the Hardware/Software FX Select button
to toggle between internal hardware and
Software eects.
2. Press and hold one of the FX Select buttons
and turn the FX Parameter encoder to scroll
through the available eects.
3. Press the FX Select button to select and load
the eect to that slot.
4. Turn the FX Parameter encoder to adjust the
selected parameter value. Press the encoder
button to scroll through available parameters of
the assigned eect. While the device menu is
open, turning this control will adjust setting
values.
Press and hold Shift and turn the encoder to
adjust the tempo of the selected BPM in tenth
increments.
5. Press an FX Assign button to select which
channel will be aected by the eects.
6. Press the FX On/Off paddle up for continuous
eect activation. Pull the paddle down for
momentary eect activation. Move the paddle
back to the center position to deactivate the
eect.
9
8
Press
Press and hold
Turn
Press
Turn to adjust the FX parameter
Press to scroll through the FX bank parameters
Press to assign to channel
Toggle up for continous eect activation
Pull down for momentary eect activation